Worksheet generator

1.C — 90 degreesKA-0032Clock geometry: hands, angles, times

• AI gave the angle for one hour mark instead of the three hour marks between the hands.
• BI divided the right angle in half, as if a quarter of the clock were 45 degrees.
• DI used a third of the clock face rather than a quarter of it.
• EI read 3 o'clock as the hands pointing in opposite directions.

2.E — 24KA-0038Building and counting with unit cubes

• AI added the three measurements together instead of multiplying them.
• BI counted one layer of 4 by 3 and forgot that the block is two layers tall.
• CI read the block as 3 by 3 by 2 because the drawing hid the far column.
• DI counted only the cubes whose faces I could actually see in the picture.

3.C — HKA-0142Line and rotational symmetry

• AI found the vertical fold and assumed a horizontal one must work too.
• BI found the horizontal fold and stopped without testing the vertical one.
• DI counted the vertical fold twice rather than testing a horizontal one.
• EI mistook turning the letter upside down for folding it, which is rotation rather than symmetry about a line.

4.E — (7, 3)KA-0145Grid coordinates and lattice reasoning

• AI moved left instead of right, subtracting the 4 rather than adding it.
• BI moved left and up, reversing both directions.
• CI swapped the two coordinates round before moving.
• DI moved up instead of down, adding the 2 rather than subtracting it.

5.C — 84KA-0027Area by subtraction (shaded regions)

• AI gave the area of the square that was cut out instead of the area that remains.
• BI subtracted the side length of the small square from the area of the big one.
• DI subtracted 4 rather than the small square's area of 16.
• EI gave the area of the whole square and forgot that a piece had been removed.

6.A — the pole points right and the triangle is below itKA-0039Reflections, rotations, translations

• BI turned the pole the right way but kept the triangle on the side it started on.
• CI turned the shape anticlockwise instead of clockwise.
• DI turned the shape half a turn instead of a quarter turn.
• EI reflected the shape in a vertical line instead of rotating it.

7.B — 40KA-0080Properties of triangles and quadrilaterals

• AI subtracted 100 from 180 and then divided by four instead of by two.
• CI assumed the two equal angles are always 45 degrees.
• DI gave what is left after taking 100 from 180 without splitting it between the two angles.
• EI made the 100 one of the equal pair, which would already exceed 180 degrees on its own.

8.B — 10KA-0087Scaling and similar figures

• AI added the difference between the areas' square roots to the side rather than multiplying by their ratio.
• CI doubled the side because the larger area is roughly double the smaller.
• DI used the ratio of the areas as if it were the ratio of the lengths, then adjusted.
• EI multiplied the side by the ratio of the areas divided by three, mixing up which ratio applies to lengths.

9.D — 120KA-0148Clock geometry: hands, angles, times

• AI gave the angle for a single hour mark rather than the four marks between the hands.
• BI counted two hour marks instead of four.
• CI assumed any gap of a few hours is a right angle, as it is at three o'clock.
• EI measured the angle the long way round the clock face instead of the smaller one.

10.B — 10KA-0082Shortest paths on and around shapes

• AI measured the straight line through the middle of the room, but the ant has to stay on the surfaces.
• CI unfolded the room but folded out the short wall rather than the one that makes the shortest route.
• DI chose an unfolding that gives a longer straight line and did not compare it with the others.
• EI walked along the edges of the room, 8 then 4 then 2, instead of cutting straight across the surfaces.